RepRap 3D Printer Heatbed MK2B 12V 24V

Out Of Stock RepRap 3D Printer Heatbed MK2B 12V 24V

Specification:

All features from MK2B and you also can operate this board now with 12v or 24v

- a central mounting hole on the front side to allow for three point mounting. This is much easier for bed leveling in comparison to 4 point mounting. First level the side with two holes and fix in place, then level the side with one hole. A glass plate is highly recommended to provide a truly flat surface and rigidity

- The pads to solder onto have been greatly increased as shown in the picture below. The picture shows the wires prepared for soldering routed through the holes for extra security. This does not remove the need to use proper strain relief.

Copper plated holes as shown in reprap wiki: reprap.org/wiki/PCB_Heatbed

  • Dimensions 214mmx 214mm
  • Laminate FR4 1.6+-0.15mm
  • 2 layer, 35m copper
  • Red Soldermask - both sides
  • White Silkscreen - both sides
  • Power Input: 12V or 24v
  • copper plated holes
  • resistance between 1.0 and 1.2 ohm

Very good in combination with RUMBA or Taurino Power

 

Write a review

Please login or register to review
  • Views: 3190
  • Brand: Tiah
  • Product Code: DZD001329
  • Availability: Out Of Stock
  • 1,600.00DA
  • Ex Tax: 1,600.00DA

Tags: reprap, 3d, printer, heatbed, mk2b, 12v, 24v