Menu
Your Cart

Raspberry Pi 4 Case Fan

Raspberry Pi 4 Case Fan
Raspberry Pi 4 Case Fan
Raspberry Pi 4 Case Fan
Raspberry Pi 4 Case Fan
Raspberry Pi 4 Case Fan
Raspberry Pi 4 Case Fan
Raspberry Pi 4 Case Fan
Raspberry Pi 4 Case Fan
Raspberry Pi 4 Case Fan
1,200.00DA
Ex Tax: 1,200.00DA

Features

    Fits perfectly into the lid of the Raspberry Pi 4 Case
    Temperature-controlled fan delivers up to 1.4CFM of air flow over the processor, memory, and power management IC
    18mm × 18mm × 10mm heatsink with self-adhesive pad improves heat transfer from the processor

Getting started
Assembling your fan with your case

    Remove any SD card, then put your Raspberry Pi into the lower half (base) of your case. Take care to align the mounting holes in the corners with the bumps in the case.
    Insert the fan into the upper half (lid) of the case, with the green label facing away from the lid. Push gently but firmly so that the two tabs on the fan housing click neatly into place inside the tabs on the lid. The slightly curved edge of the housing should be flush with the underside of the lid.
    If you are fitting the heatsink, remove the backing paper from the self-adhesive pad on the base of the heatsink, position it centrally over the processor, and gently press it into position.
    Connect the three leads from the fan to the Raspberry Pi's GPIO pins, as shown in the diagram below. Take care to connect each lead to the correct pin.
    Fit the lid of the case onto the base.

 

Write a review

Please login or register to review

GRBL


 

Mach3


 

Tags: raspberry , pi , 4 , case , fan
We use Cookies
Dzduino collects cookies to enable the proper functioning and security of our websites, and help us offer you the best possible user experience, you consent to the use of these cookies.