The correct methods of mounting the collet nut:
1. Put the chuck into the pressure cap, gently turn the clamp spring, when eccentric portion of the pressure cap recessed clamp spring groove. Along the arrow direction and use equal force to push clamp spring, can mount pressure cap.
2. Put the clamp spring and cap all together installed on the chuck body or spindle. Insert into the clamping hole after wipe the cylindrical shank, use a wrench to tighten the pressure cap, until clip firmly the tool before use.
(Note : Avoid fastening pressure cap that not installed tool, to avoid damage the clamp spring)
3. Use a wrench to loosen the pressure cap and took out the chuck or tool, remove the tool. Along the direction of the arrow push out the clamp spring. Then according to need replace other clamp spring.
Material: High Grade 65Mn spring steel
Total height: 18mm/0.71inch
Outer diameter(Max): 11.5mm/0.5inch
Run-Out Tolerance: <0.008mm
Gripping Range: 1/8MM to 10MM (1/8mm 1/4mm 1mm 1.5mm 2mm 3mm 3.5mm 4mm 4.5mm 5mm 6mm 7mm 8mm 9mm 10mm )
Fits metric shank size(s): For example,1mm Collet Fits 1mm metric shank,2mm Collet Fits 2mm metric shank